#strProject#: www.lasercutcard.co.za
#strProject# Instruction Set © Neal Crankshaw
Available from http://www.lasercutcard.co.za
This copy generated: #dateformat(now(),"dd-mmm-yyyy")# #timeformat(now(),"HH:mm:ss")# (GMT+2)
Before you beginMake images smaller | Make images bigger

The components for the kit are cut by a laser into the card and/or MDF. To keep the parts on the card there are some small tabs that you will need to cut.

When you want to remove a piece from the card, cut through the remaining lines to release the part.

I use superglue and white wood glue for construction: the superglue is used for small parts as it bonds fairly quickly (within 3 seconds) and the white glue for larger parts but feel free to use whatever glue you are comfortable with.

Parts:

  1. Main wall
  2. Main wall end pieces
  3. Battlements


Start by pre-folding the main wall (1) so that it bends cleanly

Fold it round the end pieces and use the tabs provided to glue them into place


Fold the battlement pieces back and glue them in place as shown


Finally attach the battlement to the wall. We recommend using lots of white glue to make sure your structure is as strong as possible

Read how to build your two short walls here

Then read about how to use the scrap sheets

CONGRATULATIONS! You are done.
#strProject# Instruction Set © Neal Crankshaw
Available from http://www.lasercutcard.co.za
This copy generated: #dateformat(now(),"dd-mmm-yyyy")# #timeformat(now(),"HH:mm:ss")# (GMT+2)