#strProject#: www.lasercutcard.co.za
#strProject# Instruction Set © Neal Crankshaw
Available from http://www.lasercutcard.co.za
This copy generated: #dateformat(now(),"dd-mmm-yyyy")# #timeformat(now(),"HH:mm:ss")# (GMT+2)
Before you beginMake images smaller | Make images bigger

The orc fort models come with one or both of these two scrap sheets

The components for the kit are cut by a laser into the card and/or MDF. To keep the parts on the card there are some small tabs that you will need to cut.

When you want to remove a piece from the card, cut through the remaining lines to release the part.

I use superglue and white wood glue for construction: the superglue is used for small parts as it bonds fairly quickly (within 3 seconds) and the white glue for larger parts but feel free to use whatever glue you are comfortable with.


These parts, which can be removed as one piece, are intended for the battlements


Simply finish the cuts to remove them


When attaching the pieces, you might find that one or two pieces need to be trimmed


Feel free to hack at the card with a hobby knife. It is relatively easy to cut


There is no need to cover every square centimetre with scrap. All you need to aim for is a good mix of shapes


Once you have covered both sides with scrap, you can go back and add one or two more pieces in a second layer to build up some extra detail

CONGRATULATIONS! You are done.
#strProject# Instruction Set © Neal Crankshaw
Available from http://www.lasercutcard.co.za
This copy generated: #dateformat(now(),"dd-mmm-yyyy")# #timeformat(now(),"HH:mm:ss")# (GMT+2)