#strProject#: www.lasercutcard.co.za
#strProject# Instruction Set © Neal Crankshaw
Available from http://www.lasercutcard.co.za
This copy generated: #dateformat(now(),"dd-mmm-yyyy")# #timeformat(now(),"HH:mm:ss")# (GMT+2)
Before you beginMake images smaller | Make images bigger

The components for the kit are cut by a laser into the card and/or MDF. To keep the parts on the card there are some small tabs that you will need to cut.

When you want to remove a piece from the card, cut through the remaining lines to release the part.

I use superglue and white wood glue for construction: the superglue is used for small parts as it bonds fairly quickly (within 3 seconds) and the white glue for larger parts but feel free to use whatever glue you are comfortable with.


Prefold the wall so that it bends cleanly


Fold the back and sides round and glue them in place along their edges


Fold the front up and glue it in place


Glue the side piece in place as shown


Finally we recommend using lots of white glue to make sure your structure is as strong as possible.

Smear it into all the joins with your fingers

Now read about how to use the scrap sheets

CONGRATULATIONS! You are done.
#strProject# Instruction Set © Neal Crankshaw
Available from http://www.lasercutcard.co.za
This copy generated: #dateformat(now(),"dd-mmm-yyyy")# #timeformat(now(),"HH:mm:ss")# (GMT+2)