#strProject#: www.lasercutcard.co.za
#strProject# Instruction Set © Neal Crankshaw
Available from http://www.lasercutcard.co.za
This copy generated: #dateformat(now(),"dd-mmm-yyyy")# #timeformat(now(),"HH:mm:ss")# (GMT+2)
Before you beginMake images smaller | Make images bigger

Welcome to the #strProject# build instructions.

The card has been laser cut. To keep the parts on the card there are some small tabs that you will need to cut.

When you want to remove a piece from the card, cut through the remaining lines to release the part.

I use superglue for construction as it bonds fairly quickly (within 3 seconds) but feel free to use whatever glue you are comfortable with.

Begin by removing the parts shown..

These are the top and sides of the sentinal (the big piece) plus two backing plates.

Remove the glyphs from the big pieces but don't throw them away.


Flip the big piece over and glue the backing plates over the holes left by the glyphs.

Remove the small circles from the glyphs

Flip the piece back over and glue the circles on to the backing plate


Now do exactly the same thing with the other two side pieces


Fold the main piece over and glue the sides on to it.

Then glue the top piece on.

Remove the bottom detail pieces as shown

Two of these are slightly wider than the other two.



Glue the NARROWER pieces on to the sides of the sentinal on opposite sides.

Then glue the WIDER pieces onto the remaining sides.

Dry-fit this if you are confused.

Now all you have to do is assemble the Cyborg Crystal Top

This has its own instructions here: CYBORG CRYSTAL TOP

#strProject# Instruction Set © Neal Crankshaw
Available from http://www.lasercutcard.co.za
This copy generated: #dateformat(now(),"dd-mmm-yyyy")# #timeformat(now(),"HH:mm:ss")# (GMT+2)