#strProject#: www.lasercutcard.co.za
#strProject# Instruction Set © Neal Crankshaw
Available from http://www.lasercutcard.co.za
This copy generated: #dateformat(now(),"dd-mmm-yyyy")# #timeformat(now(),"HH:mm:ss")# (GMT+2)
Before you beginMake images smaller | Make images bigger

Welcome to the #strProject# build instructions.

This piece is used in several different cyborg kit so it has its own instruction set.

The card has been laser cut. To keep the parts on the card there are some small tabs that you will need to cut.

When you want to remove a piece from the card, cut through the remaining lines to release the part.

I use superglue for construction as it bonds fairly quickly (within 3 seconds) but feel free to use whatever glue you are comfortable with.

Begin by removing the parts shown for the base as shown.

Glue them together


Remove the support stands. There are four big ones and eight smaller ones

Glue smaller ones to the sides of the bigger ones.

Make sure that the sides shown by the arrow line up and are flush. This is where the crystal will attach



Once you have all four done, simply glue them to the base.

You are done!

#strProject# Instruction Set © Neal Crankshaw
Available from http://www.lasercutcard.co.za
This copy generated: #dateformat(now(),"dd-mmm-yyyy")# #timeformat(now(),"HH:mm:ss")# (GMT+2)