#strProject#: www.lasercutcard.co.za
#strProject# Instruction Set © Neal Crankshaw
Available from http://www.lasercutcard.co.za
This copy generated: #dateformat(now(),"dd-mmm-yyyy")# #timeformat(now(),"HH:mm:ss")# (GMT+2)
Before you beginMake images smaller | Make images bigger

The components for the kit are cut by a laser into the card and MDF. To keep the parts on the card there are some small tabs that you will need to cut.

When you want to remove a piece from the card, cut through the remaining lines to release the part.

The MDF pieces only need to be pushed out of the frame. Some of them are quite thin so be careful with these pieces.

I use superglue for construction as it bonds fairly quickly (within 3 seconds) but feel free to use whatever glue you are comfortable with. White wood glue also works well.


Start by removing the main turret piece

Prefold all the folds to get it started





Starting with the right hand side, glue the sides to the top of the turret

Then do the left

Finally fold the bottom up and glue that





Add the extra details as shown

Assemble the hinge and mount the turret as shown in the other two turret instruction manuals

CONGRATULATIONS! You are done.
#strProject# Instruction Set © Neal Crankshaw
Available from http://www.lasercutcard.co.za
This copy generated: #dateformat(now(),"dd-mmm-yyyy")# #timeformat(now(),"HH:mm:ss")# (GMT+2)