#strProject#: www.lasercutcard.co.za
#strProject# Instruction Set © Neal Crankshaw
Available from http://www.lasercutcard.co.za
This copy generated: #dateformat(now(),"dd-mmm-yyyy")# #timeformat(now(),"HH:mm:ss")# (GMT+2)
Before you beginMake images smaller | Make images bigger

The components for the kit are cut by a laser into the card and MDF. To keep the parts on the card there are some small tabs that you will need to cut.

When you want to remove a piece from the card, cut through the remaining lines to release the part.

The MDF pieces only need to be pushed out of the frame. Some of them are quite thin so be careful with these pieces.

I use superglue for construction as it bonds fairly quickly (within 3 seconds) but feel free to use whatever glue you are comfortable with. White wood glue also works well.



Start by removing the main turret piece

Turn it over and youwill notice that there is one perforated piece that needs to bend the other way






Fold down the front and glue it in place.

Then fold down all the sides and glue them to the base as shown




Assemble the missile tubes as shown


Glue the hatch, periscope and gun mount on as shown


Assemble the sensor package as shown


Fold and glue the box containing the ... er... something important as shown


Glue on the missile mount as shown


Assemble the final pieces as shown



Glue the hinge pieces together as shown. Slot this into the hull of the vehicle and then glue the turret onto the hinge (NOT the hull)

That way you will know it is centred

CONGRATULATIONS! You are done.
#strProject# Instruction Set © Neal Crankshaw
Available from http://www.lasercutcard.co.za
This copy generated: #dateformat(now(),"dd-mmm-yyyy")# #timeformat(now(),"HH:mm:ss")# (GMT+2)