#strProject#: www.lasercutcard.co.za
#strProject# Instruction Set © Neal Crankshaw
Available from http://www.lasercutcard.co.za
This copy generated: #dateformat(now(),"dd-mmm-yyyy")# #timeformat(now(),"HH:mm:ss")# (GMT+2)
Before you beginMake images smaller | Make images bigger

The components for the kit are cut by a laser into the card. To keep the parts on the card some of the lines are incomplete.

When you want to remove a piece from the card, look for the incomplete lines. You will only need to cut these lines to release the part.

I use superglue for construction as it bonds fairly quickly (within 3 seconds) but normal white wood glue works just as well and is a lot cheaper.

Start by removing the walkway and the four small strips of card from one of the frames.

Glue the thin strips together to make two thicker strips. These are reinforcing pieces that will help keep the bridge steady

Next remove the bridge sides and glue the one layer onto the other as shown

Now glue the sides onto the walkway. Use the reinforcing parts to make sure the sides are vertical

Follow these steps for the other bridge

It fits together in exactly the same way

As an optional final step, we suggest adding a thick strip of white glue all along the bottom pieces. This will serve to strengthen your bridge and protect it from the stress of the Evil Game Store Kid.

CONGRATULATIONS! You are done.
#strProject# Instruction Set © Neal Crankshaw
Available from http://www.lasercutcard.co.za
This copy generated: #dateformat(now(),"dd-mmm-yyyy")# #timeformat(now(),"HH:mm:ss")# (GMT+2)