#strProject#: www.lasercutcard.co.za
#strProject# Instruction Set © Neal Crankshaw
Available from http://www.lasercutcard.co.za
This copy generated: #dateformat(now(),"dd-mmm-yyyy")# #timeformat(now(),"HH:mm:ss")# (GMT+2)
Before you beginMake images smaller | Make images bigger

The components for the kit are cut by a laser into the card. To keep the parts on the card some of the lines are incomplete.

When you want to remove a piece from the card, look for the incomplete lines. You will only need to cut these lines to release the part.

I use superglue for construction as it bonds fairly quickly (within 3 seconds) but normal white wood glue works just as well and is a lot cheaper.

The vents are simply two layers of card that are glued together as shown



For the small airconditioning unit, start by removing the main body.

Although the fold lines are already pre-scored, it is a good idea to make them deeper with a sharp hobby knife so that all the pieces bend cleanly.

Fold up the main body and glue as shown


For the stand, assemble as shown



For the large rooftop airconditioning unit, remove the main parts as shown

Fold and glue together as indicated (do a dry fit first)



Remove the detail pieces and attach them as shown

CONGRATULATIONS! You are done.
#strProject# Instruction Set © Neal Crankshaw
Available from http://www.lasercutcard.co.za
This copy generated: #dateformat(now(),"dd-mmm-yyyy")# #timeformat(now(),"HH:mm:ss")# (GMT+2)