#strProject#: www.lasercutcard.co.za
#strProject# Instruction Set © Neal Crankshaw
Available from http://www.lasercutcard.co.za
This copy generated: #dateformat(now(),"dd-mmm-yyyy")# #timeformat(now(),"HH:mm:ss")# (GMT+2)
Before you beginMake images smaller | Make images bigger

The components for the kit are cut by a laser into the card. To keep the parts on the card there are a few tabs that you will have to cut through.

I use white glue or superglue for construction but feel free to use whatever you are comfortable with.

Remove the main container body and prefold it

Glue the sides on using the tabs provided

[OPTIONAL] Drip some white glue down the corner joins - when this dries it will make the whole container even stronger

Glue the corrugated sides on each side

Glue the thin outer layers on each side.

Save one of the pieces that you remove from the centre of these pieces

Glue the thin outer layers on to the front and back

Assemble the roof piece as shown

The bottom layer is one of the inserts you saved from the thin outer layers

You are done.

[OPTIONAL] You can leave the roof off. This lets you use the container as a dice box or to keep your measuring tape in.

#strProject# Instruction Set © Neal Crankshaw
Available from http://www.lasercutcard.co.za
This copy generated: #dateformat(now(),"dd-mmm-yyyy")# #timeformat(now(),"HH:mm:ss")# (GMT+2)