#strProject#: www.lasercutcard.co.za
#strProject# Instruction Set © Neal Crankshaw
Available from http://www.lasercutcard.co.za
This copy generated: #dateformat(now(),"dd-mmm-yyyy")# #timeformat(now(),"HH:mm:ss")# (GMT+2)
Before you beginMake images smaller | Make images bigger

The components for the kit are cut by a laser into the card and/or MDF. To keep the parts on the card there are some small tabs that you will need to cut.

When you want to remove a piece from the card, cut through the remaining lines to release the part.

I use superglue and white wood glue for construction: the superglue is used for small parts as it bonds fairly quickly (within 3 seconds) and the white glue for larger parts but feel free to use whatever glue you are comfortable with.


Start by gluing the back (A) to one of the top/bottom pieces


Next add the side angle pieces (B)


The add the sides (C).

The sides look similar to the front (E) but part (E) has a small square etched into it


Next add the front angles (D)


Finally, add the front (E)


To make your model as strong as possible, add a thick layer of glue along all innre joins and spread it into the joins with the back of a paintbrush


When attaching the second roof/bottom, start by getting it fitted at one end and then work your way along


If it slips in to the building, you can gently lever it out with your knife.

CONGRATULATIONS! You are done.
#strProject# Instruction Set © Neal Crankshaw
Available from http://www.lasercutcard.co.za
This copy generated: #dateformat(now(),"dd-mmm-yyyy")# #timeformat(now(),"HH:mm:ss")# (GMT+2)