#strProject#: www.lasercutcard.co.za
#strProject# Instruction Set © Neal Crankshaw
Available from http://www.lasercutcard.co.za
This copy generated: #dateformat(now(),"dd-mmm-yyyy")# #timeformat(now(),"HH:mm:ss")# (GMT+2)
Before you beginMake images smaller | Make images bigger

The components for the kit are cut by a laser into the card and/or MDF. To keep the parts on the card there are some small tabs that you will need to cut.

When you want to remove a piece from the card, cut through the remaining lines to release the part.

Always pre-fold any parts with folds. If the fold is not crisp and clean, gently score the fold with a sharp knife.

I mostly use white wood glue and occassionally a bit of superglue for construction: the superglue is used for small parts as it bonds fairly quickly (within 3 seconds) and the white glue for larger parts but feel free to use whatever glue you are comfortable with.

The battlefield is a dangerous place: it is recommended at each step to put a thick strip of white glue along the inside of all joins to make your model as strong as possible






CONGRATULATIONS! You are done.
#strProject# Instruction Set © Neal Crankshaw
Available from http://www.lasercutcard.co.za
This copy generated: #dateformat(now(),"dd-mmm-yyyy")# #timeformat(now(),"HH:mm:ss")# (GMT+2)